Программист STLINK-V3set оригинальный
В наличии
Артикул
12423624782
9 250,00 грн.
программист stlink-V3set Original
Programmer main module in the housing
Extension module
STM8 and STM32 programming
Supports DFU (прямое обновление прошивки)
JTAG / SWD (Serial Wire Debugging)
Power supply 3 ÷ 3.6 V, The pins tolerate 5 V at the input
Connectors for stdc14 ribbon cables for MIPI10 / STDC14 / MIPI20 (1.27 mm pitch)
JTAG support
Support for SWD together with SWV (Serial Wire Viewer)
SWIM (using the mb1440 Adapter plate)
Power 1.65 ÷ 5.5 V
Swim connector in 2.54 mm pitch
Low-speed and high-speed support
Virtual COM port (VCP)
Power supply 3 ÷ 3.6 V, for UART tolerance 5 V at the input
VCP частота до 15 МГц
Available on stdc14 connector
USB к SPI / UART / I2C / CAN / GPIO мульти конвертер
Power supply 3 ÷ 3.6 V, The pins tolerate 5 V at the input
These signals are available on the Adapter board (MB1440)
Drag-and-drop programming
Two светодиодные фонари
Power
Communication
The ST-Link V3 programmer from the ST company. It is a standalone programmer that is used to STM8 and STM32 microcontrollers.
It is a set, so it consists of several elements:
Unfortunately, the housing does not contain an additional module, but it is possible to 3D print an additional part of the housing.
программист подключается к компьютеру через интерфейс USB 2.0.
the possibilities of ST-Link in the third version are enormous. This system enables:
-
БЫСТРАЯ ДОСТАВКА ПО ВСЕМ ЗАКАЗАМ
-
ВОЗВРАТ ДЕНЕГ В ТЕЧЕНИЕ 14 ДНЕЙ
-
БЕЗОПАСНЫЕ ПОКУПКИ
